Will this bumper accept my factory fog light cutouts?

The GT-2 profile includes provisions for fog light installation. Before cutting, test-fit the bumper and mark the exact position of your existing fog light housings to ensure alignment with the panel cutouts.

Does the two-piece design make installation easier?

Yes — the split construction lets you remove and install each section independently, which simplifies access to fastening points and reduces the risk of panel stress during handling compared to a single-piece bumper.

What prep work should I do before painting?

Sand and prep the surface with appropriate grit to promote paint adhesion, then apply your chosen primer and topcoat. Refer to your paint supplier's recommendations for FRP surface preparation to ensure long-term color and finish durability.