2013-2018 Ford Fiesta ST Hatchback - Tail Light Outer Trim Accent Vinyl Overlay

If you're really looking to change up the look of your Fiesta ST Hatch in a subtle yet BIG way! This simple vinyl accent truly transforms the rear end and is very easy to install even for DIY beginners. Made from high quality wrap material instead of sticker vinyl, it gives you a much easier install experience. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.

INSTALL GUIDE

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.

FULL INSTALL: After the surface is clean and you have read and completed DRY INSTALL BASICS, take note that this product is fairly large and can be a lot of material to handle when placing. Be sure not to stretch or warp the overlay, it is pre-cut to sit into place perfectly when placed correctly. After removing it from the backing paper you want to make sure that the vinyl does not come in contact with any dirty surfaces or it will effect the finish of your end result. Note: This product is easy to install although it does take patience to get it to sit in place correctly. Do not rush the installation.

First, line up the top corner of the tail light with the corresponding corner of the overlay. Take the overlay off of the backing paper, line up the corner and carefully lay the rest of the vinyl into place following the outer edge of the tail light until you get to the rear face of the light in which you will then tuck around to the trunk around.

The top edge follows the inner edge with the corresponding inner edge of the vinyl that way you should have no red showing on the outer edge of the tail light.

Once the vinyl is placed correctly, starting from the center of the overlay, apply firm pressure with a pro-felt squeegee moving outwards to remove any and all air from underneath the vinyl.

Minor trimming and or tucking required along the outer edge of the tail light depending on your placement of the product. A small amount of excess material was given around the outer edge to insure full coverage.

Post heat the overlay, simply by letting your vehicle sit out in the warm sun for a couple of hours or, use a heat gun to speed up the process.

SUPERIOR QUALITY

• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.

• Car wash safe.

• Can be removed without any damage to surface.

• 1-3 year life expectancy.

• Check your local laws and regulations

>> DISCLAIMER INFORMATION

DIFFICULTY RATING 2/5

MORE >> Difficulty Rating Information