2014-2019 GMC Sierra | 2014-2019 Chevy 1500 - Rear Window American Flag Decal - Satin Black or Satin Grey (For rear windows with power slider)

Notice: This is a custom product that takes time to produce. If this product is in addition to your order you can expect a 3-5 day production delay. We do try to get these flag decals out as soon as possible but please be patient with us.

Our American Flag Window Decal takes one side of your vehicles rear window and turns it into a great focal point with this patriotic flag decal. It comes in a satin black OR satin grey finish that looks great from every angle.

Product Picture Shown is the Grey Option

PERFECT FIT GUARANTEED.

Pre cut to fit without any trimming required depending on your placement. This specific product was created approximately 1/16 of an inch undersized to the outline of the window to minimize placement error and the possibility of needing to trim the product in any area.

SUPERIOR QUALITY MATERIALS.

Premium only uses the highest quality cast vinyl on the market designed to last at least 3 years of harsh outdoor weather. It's far more durable than our competitors' cheap, calendared vinyl film which starts to degrade in just a couple of years!

INSTALL:

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

*IMPORTANT*

DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.

After reading the DRY INSTALL BASICS, you can continue to this portion of the install.

For this install we recommend a second set of hands to help you place this decal because of the large nature of the product itself. Remove the decal from the backing paper with the transfer tape attached.

Now without letting the decal stick to the window just yet, line up the right side top and bottom corners, while the other person lines up the left, top and bottom corners. Place decal on the window, then apply firm pressure starting from the center of the window and squeegee the material moving outwards from the center continuously until you can see the vinyl embossed in the transfer tape.

Now, Peel the transfer tape away from the decal, start in one corner and peel the transfer tape back directly over itself, parallel to the window. Move slowly, you want to make sure the vinyl stays on the window not the transfer tape, if some parts do not release from the transfer tape, STOP lay that section back down before peeling any further and squeegee the section down again. No trimming should be required unless placement of the decal is incorrect.