Hot-dip galvanizing immerses the steel wire in molten zinc, creating a thick, metallurgically bonded coating that typically lasts significantly longer than electro-galvanized coatings in outdoor environments. Electro-galvanizing applies a thinner zinc layer via electrical current and is generally less durable under prolonged moisture, UV, and agricultural chemical exposure. For long-term farm use, hot-dip galvanized wire is the recommended choice.

This fence is suitable for containing or excluding cattle, horses, sheep, goats, hogs, dogs, and deer. The graduated mesh design — with smaller openings at the bottom — helps prevent smaller animals and young livestock from passing through the lower section of the fence. For very small animals such as rabbits or poultry, additional fencing at the base may be needed.

Graduated mesh means the spacing between horizontal wires decreases from the top of the fence to the bottom. The tighter spacing at ground level prevents small animals, lambs, piglets, and young livestock from squeezing through, while the wider spacing at the top reduces material cost without compromising containment for larger animals. This design is standard in agricultural field fencing and is sometimes referred to as "hinge joint" or "field fence" style.

Each roll covers 164 linear feet (approximately 50 meters). To estimate the number of rolls needed, measure the total perimeter of the area you want to fence, then divide by 164. Add 5–10% for corners, gates, and overlaps. For example, a 1-acre square lot has a perimeter of approximately 835 feet, requiring approximately 6 rolls.

For most livestock applications, post spacing of 8 to 12 feet is generally recommended. Closer spacing (8 feet) provides greater rigidity and is preferred for high-pressure areas such as corners, gates, and areas where animals push against the fence. Wider spacing (12 feet) is typically used for straight runs in lower-pressure areas. Brace posts at corners and ends are strongly recommended for proper tensioning.

Yes. At 5 feet tall, this fence provides a meaningful barrier against deer in many situations. However, deer are capable of jumping fences up to 8 feet or higher under pressure. For high-deer-pressure areas such as gardens or orchards, a taller fence or a double-fence system may be more effective. For general farm perimeter use and moderate deer pressure, 5 feet is a commonly used and practical height.

Typical installation tools include a post driver or post hole digger, fence stretcher or come-along, wire cutters, staples or fence clips (for wooden posts) or wire ties (for T-posts), a level, and work gloves. The specific tools required will depend on your post type, terrain, and total fence length. Proper tensioning tools are important for achieving a taut, long-lasting installation.

Yes. Woven wire fencing can generally be installed on sloped terrain by stepping the fence panels or racking the wire to follow the ground contour. On steep slopes, additional posts and careful tensioning are recommended to maintain consistent ground contact and prevent gaps at the base that animals could pass through.